SATO GT424 - Manual (Page 77)

Section 4: Cleaning and Maintenance
GT Series Operator’s Manual Page 4-1
4
CLEANING AND MAINTENANCE
4.1 INTRODUCTION
This section provides information on user maintenance for the GT Series printers. The
following information is covered here:
• Cleaning the Print Head, Platen and Rollers
• Adjusting print quality
4.2 CLEANING THE PRINT HEAD, PLATEN AND ROLLERS
The print head not only generates printouts of barcodes, but also graphics and text. To produce
optimal printing, it must be kept clean in spite of the dirt and adhesive that constantly
accumulates on its print surface. Furthermore, dirt can accumulated along the label path,
affecting parts like sensors and guides, and reducing their performance.
Therefore, it is important to clean these important components periodically. A printer cleaning set
and a set of cleaning sheets is provided with every printer. If any of the cleaning items need
replacement, contact your authorized SATO dealer.
When to clean with the supplied cleaning set
♦
Printer head, platen roller, paper sensor, and label
guide: clean after using up every other roll of paper,
or each time after printing 150 m.
♦
Other parts: clean after finishing every six rolls of
paper, or every time after printing 900 m.
When to clean with the supplied cleaning sheet
♦
Printer head, platen roller: clean after using every six
rolls of paper, or every time after printing 900 m.