SATO GT424 - Manual (Page 42)

Section 3: Configuration and Operation
Page 3-6 GT Series Operator’s Manual
3.5 USER MODE
The following settings are available in User Mode:
• OFFSET VOLUME (volume of the built-in buzzer/speaker)
• PRINT SPEED (print speed setting)
• PRINT DARKNESS (print density setting)
• PRINT OFFSET (print position correction setting)
• ZERO SLASH (zero slash changeover setting)
• JIS CODE (JIS code changeover setting)
• KANJI FONT (Kanji font changeover setting)
• CHARACTER PITCH (proportional pitch setting)
3.5.1 Entering User Mode
1. Press the LINE button to take the printer OFFLINE.
2. Pull down the cover of the Operation Panel and press ENTER.
The ONLINE MODE screen appears.
3. Press the arrow buttons until you see “USER
MODE”, then press ENTER.
Note:
The bottom right-hand corner of the screen sometimes displays
one to four arrow symbols (see circled symbols on the right).
Each arrow symbol represents the corresponding arrow button
on the operation panel which is valid for the changing the current
screen or its settings.
4. When the first User Mode screen appears, you will need the
yellow screwdriver (fastened to the Operation Panel flap), to
adjust the OFFSET VOLUME, PITCH, OFFSET and
DARKNESS potentiometers. See Section 3.5.2 Setting Print
Speed.
5. Subsequently, pressing the ENTER button brings you to screens
for setting PRINT SPEED, PRINT DARKNESS and OFFSET. At
any time, pressing CANCEL takes you back one screen.
Pressing the FUNCTION button returns you immediately to the
main User Mode screen.