SATO GT424 - Manual (Page 30)

SECTION 2: INSTALLATION
Page 2-18 GT Series Operator’s Manual
2.3 LOADING LABELS AND TAGS (CONT’D)
6. Pull out the purple label damper to release the label
guide assembly. The label guide will drop downwards.
7. Insert the paper so that it passes under the label guide
and paper sensor.
8. Adjust the label guide knob so that it lightly touches the
edge of the label. Fasten the knob tightly.
9. Now remount the print head by pushing down on the
Head lock lever. The print head should lock into place
firmly.
10. If desired, close the main cover and do a test print to
check that the label roll has been loaded properly. Be
careful not to get your fingers caught at the bottom
ledge when you are closing the main cover.
Note:
The procedure described above is recommended for
loading a stack of fanfold paper that is 20 cm in height or
higher.
For loading smaller reams of fanfold paper, use the rear
cover as described in the previous section. Avoid loading
stacks of paper from the rear if the height is greater than
20 cm.
Caution
• When replacing paper, bear in mind that the print head and its surrounding area remain hot. Keep your fingers away from
these areas to prevent injury.
• Avoid touching even the edge of the print head with your bare hands.
Pull the
purple
label
damper
Adjust
the label
guide
knob
Label
sensor
Print
Head
Head lock
lever