SATO GT424 - Manual (Page 60)

Section 3: Configuration and Operation
Page 3-24 GT Series Operator’s Manual
3.10 HEX DUMP MODE
3.10.1 Entering HEX Dump Mode
1. Press the LINE button to take the printer OFFLINE.
2. Pull down the cover of the Operation Panel and press ENTER.
The ONLINE MODE screen appears.
3. Press the arrow buttons until you see “HEX DUMP
MODE”, then press ENTER to perform the first setting. At any
time within this mode, pressing CANCEL takes you back one
screen. Pressing the FUNCTION button returns you immediately
to the main Hex Dump screen.
3.10.2 Selecting Data To Dump
Here you can choose to dump either incoming data (receive data)
or print data already stored in the buffer (receive buffer) .
Press the buttons to choose RECEIVE DATA or RECEIVE
BUFFER. Note that RECEIVE BUFFER cannot be selected when
there is no received data.
Press the ENTER button to confirm the setting and proceed to the
next screen.
3.10.3 Controlling the Hex Dump Mode
During the HEX Dump, the following screen appears. The number
of labels printed will be shown. When printing is done, press the
LINE button to take the printer OFFLINE. The press ENTER to
return to the main HEX DUMP Mode screen.
If you dumping the RECEIVE BUFFER, take the printer OFFLINE to
stop any incoming data from affecting the buffer. Only then can the
buffered data be printed. The printer goes ONLINE automatically
after the printing.