Optional accessories, 1 introduction, 2 available interface boards – SATO GT424 User Manual
Page 149: 1 introduction -1, 2 available, Interface, Boards -1, Section 7: optional accessories
Section 7: Optional Accessories
GT Series Operator’s Manual
Page 7-1
7
OPTIONAL ACCESSORIES
7.1 INTRODUCTION
This section contains details of the optional accessories available for the GT printer series:
• Interface boards
• Peelers
• Cutters
• Winders
• RFID unit
• Additional memory
7.2 AVAILABLE INTERFACE BOARDS
Interface boards enable the printer to exchange data with computers, computer networks and
related input/output devices. By installing different interface boards, you can adapt GT printers to
fit in a wide range of related equipment and usage scenarios.
The following interface boards are available for the GT series:
¤ Parallel interface board (IEEE1284) (optional or bundled)
¤ Serial interface board (RS-232C) (optional)
¤ USB interface board (optional)
¤ 10BaseT/100Base-TX LAN interface board (optional)
¤ Wireless LAN IEEE802.11b interface board (optional)
¤ 10BaseT/100Base-TX mini LAN board (optional)
¤ EXT connector (external signal interface) (optional)
For more advanced details on interfaces, see Section 5:
Interface Specifications.
Caution
Before installing or removing interface boards, be sure to turn off
the printer first. Discharge static electricity from your body before touching any of the electronic
parts. Failure to observe these precautions can result in severe damage to the components.
Mini
LAN
board
Interface
connector