Star Micronics Line Thermal/Dot Printer - Manual (Page 123)

Rev. 0.00
3-111
STAR Line Mode Command Specifications
ESC RS C n
[Name] Select/cancel 2-color print mode
[Code]
ASCII ESC RS C n
Hexadecimal 1B 1E 43 n
Decimal 27 30 67 n
[Defined Area] Thermal : 0 ≤ n ≤ 2, 48 ≤ n ≤ 50 (“0” ≤ n ≤ “2”), n = 16, n =32
Slip : -
Validation : -
[Initial Value] Thermal : n = 0, 48
Slip : -
Validation : -
[Function]
<Thermal>
n Print Mode Specification
0, 48 Single Color Mode
1, 49 2-color Mode
16 Low-power Consumption Mode
32 Double Resolution Mode
• This command is ignored when the low-power consumption mode is selected by the DIP switches.
• The specification of this command is not cleared by ESC @ CAN.
• Prints data in line buffer, if unprinted data exists in the line buffer.
• This command is processed after quitting the current print.
• Commands that select the same mode are ignored in the currently selected mode.
<Slip>, <Validation>
Only setting is valid
Setting is valid after switching to thermal.