Star Micronics Line Thermal/Dot Printer - Manual (Page 147)

Rev. 0.00
3-135
STAR Line Mode Command Specifications
ESC GS x S 0 n p1 p2
[Name] PDF417 bar code size setting
[Code]
ASCII ESC GS x S 0 n p1 p2
Hexadecimal 1B 1D 78 53 30 n p1 p2
Decimal 27 29 120 83 48 n p1 p2
[Defined Area] Thermal : n = 0, 1
When n = 0 1 ≤ p1 ≤ 99, 1 ≤ p2 ≤ 99
When n = 1 p1 = 0 or 3 ≤ p1 ≤ 90, p2 = 0 or 1 ≤ p2 ≤ 30 (However, this excludes p1 = p2 =
0.)
Slip : -
Validation : -
[Initial Value] Thermal : n = 0, p1 = 1, p2 = 2
Slip : -
Validation : -
[Function]
<Thermal>
Parameter details
n
(Bar Code Size Specification Method)
p1, p2
(Size Specification)
0 USE_LIMITS
(Specifies ratio of bar code verti-
cal/horizontal directions)
p1: p2: Distribution ratio of vertical (p1) and horizontal (p2)
However, p1: p2 = 1 : 99 to 10:1 ( p1/p2 = 0.01 to 10)
1 USE_FIXED
(Specifies number of lines, and
number of columns in the bar
code.)
p1: Number of lines (0, 3 to 90); p2: Number of columns (0, 1
to 30)
However, p1 * p2 ≤ 928
If either p1 or p2 is set to 0, it indicates that that value is vari-
able.
Setting of the bar code size using this command specifies the general size. The size is automatically
corrected by other settings.
<Slip>, <Validation>
Only setting is valid
Setting is valid after switching to thermal.
ESC GS x S 1 n
[Name] Set PDF417 ECC (security level)
[Code]
ASCII ESC GS x S 1 n
Hexadecimal 1B 1D 78 53 31 n
Decimal 27 29 120 83 49 n
[Defined Area] Thermal : 0 ≤ n ≤ 8
Slip : -
Validation : -
[Initial Value] Thermal : n = 1
Slip : -
Validation : -
[Function]
<Thermal>
Parameter details
• n: : ECC level (0 to 8)
<Slip>, <Validation>
Only setting is valid
Setting is valid after switching to thermal.