Star Micronics Line Thermal/Dot Printer - Manual (Page 35)

Rev. 0.00
3-23
STAR Line Mode Command Specifications
SI
[Name] Select upside-down printing
[Code]
ASCII SI
Hexadecimal 0F
Decimal 15
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Upside-down printing cancelled
Slip : Upside-down printing cancelled
Validation : Upside-down printing cancelled
[Function] Specifies upside-down printing
This command is enabled only when at the top of the line.
Upside down and right-side up characters cannot both exist in the same line.
This command is enabled for following.
• ANK characters
• Kanji characters
• Bit images
• Logos
• Bar codes
<Slip>, <Validation>
When page mode is selected, only setting is valid
Setting is valid after switching to line mode.
(Note) The settings by this command are valid for all stations.
DC2
[Name] Cancel upside-down printing
[Code]
ASCII DC2
Hexadecimal 12
Decimal 18
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Upside-down printing cancelled
Slip : Upside-down printing cancelled
Validation : Upside-down printing cancelled
[Function] Cancels upside-down printing
This command is enabled only when at the top of the line.
(Note) The settings by this command are valid for all stations.