Star Micronics Line Thermal/Dot Printer - Manual (Page 37)

Rev. 0.00
3-25
STAR Line Mode Command Specifications
3-3-4) Line Spacing
LF
[Name] Line feed
[Code]
ASCII LF
Hexadecimal 0A
Decimal 10
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : 1/6 inch line feed
Validation : 1/6 inch line feed
[Function] Feeds the currently specified amount of paper.
If print data exists in the line buffer, it prints that data.
<Thermal>
Initial value of line feed amount is set by the memory switch.
CR
[Name] Carriage return (Print line feed)
[Code]
ASCII CR
Hexadecimal 0D
Decimal 13
[Defined Area] Thermal : -
Slip : -
Validation : -
[Initial Value] Thermal : Memory switch setting
Slip : Memory switch setting
Validation : Memory switch setting
[Function] Specifies the function according to the memory switch value.
See each printer’s product specifications manual for details on the memory switch settings.
<Thermal>
Memory SW Function
Condition (1) Ignored
Condition (2) Same as the LF code.
<Slip>, <Validation>
Memory SW Function
Condition (1) Ignored
Condition (2) Same as the LF code.
Condition (3) Executes only printing, with no paper feed.