Star Micronics Line Thermal/Dot Printer - Manual (Page 185)

Rev. 0.00
5-10
STAR LIne Mode Command Specifications
<Printer status 4 Sensor Information (Sixth Byte)>
Bit Contents Status By model
“0” “1” HSP7000
7 Fixed at “0” - -
6 Not Used (Fixed at “0”) - -
5 Not Used (Fixed at “0”) -
4 Fixed at “0” - -
3 Paper end Paper No paper ○
2 Paper Near-end (Inner Side) Paper No paper ○
1 Paper Near-end (Outer Side) Paper No paper ×
0 Fixed at “0” - -
<Printer status 5 Sensor Information (Seventh Byte)>
Bit Contents Status By model
“0” “1” HSP7000
7 Fixed at “0” - -
6
Slip/Validation
Condition ○
5
Slip/Validation
Condition ○
4 Fixed at “0” - -
3 Slip BOF Detector Paper No paper ○
2 Slip TOF Detector Paper No paper ×
Slip COF Detector Paper No paper ○
1 Presenter Paper Detector No paper Paper ×
Stack Sensor Paper Detector No paper Paper ×
Peeling Sensor Paper Detector No paper Paper ×
Slip TOF Detector Paper No paper ○
0 Fixed at “0” - -
Slip/Validation Condition Support Table
Bit 6 Bit 5 Condition
0 0 Slip Paper (MICR Target)
0 1 Slip Paper (Print Target)
1 0 Validation Paper (Print Target)
1 1 No paper