Star Micronics Line Thermal/Dot Printer - Manual (Page 140)

Rev. 0.00
3-128
STAR LIne Mode Command Specifications
ESC GS / 3 nL nH d1 d2 … dk
[Name] Set user macro 1
[Code]
ASCII ESC GS / 3 nL nH d1 d2 ... dk
Hexadecimal 1b 1d 2f 33 nL nH d1 d2 ... dk
Decimal 27 29 47 51 nL nH d1 d2 ... dk
[Defined Area] Thermal : 1 ≤ nL ≤ 64, nH = 0
1 ≤ (nL + nH x 256) ≤ 64
dk = (nL + nH x 256)
0 ≤ d ≤ 255
Slip : -
Validation : -
[Initial Value] Thermal : No user macro 1 setting
Slip : -
Validation : -
[Function]
<Thermal>
Sets user macro 1 for the Auto Logo function.
This setting is registered to non-volatile memory by the ESC GS / W command.
This command is ignored while Auto Logo is executing.
Registers print data in user macro 1.
Maximum 64 bytes of registered data
Note that registering Auto Logo command characters in the user macros is prohibited.
<Slip>, <Validation>
Only setting is valid
Setting is valid after switching to thermal.