Speco Technologies & IP-WDRB1 - Manual (Page 115)

115
IP Camera User’s Manual Speco Technologies
6. Network Environment
It is required to follow the recommendation of the environment where THE CAMERA
will be
installed or the similar environment .
6-1. Private line Environment
Usually Company, University, Research center use the leased line. They use many public IP
addresses. In order to install THE CAMERA under this environment, select “Static IP Address” in
‘Static IP Setting’ of ‘3. Basic Setting’ and input IP address, subnet mask and gateway. If there is
DHCP server on the network, select ‘Dynamic IP Address’ in ‘Dynamic IP’ of ‘3. Basic Setting’. You
can get all the information (IP address, subnet mask, gateway, DHCP server) from the network
administrator. Sometimes, the THE CAMERA may not work properly if the user installed firewall for
security purpose. In this case, open the port on the THE CAMERA, then it will work properly. You
can check the current port of THE CAMERA from the “Administrator's Page”->”Network Setting”-
>”Port Setting” (see ‘ 3. Basic Setting ‘). The default port is set on ex-factory as follows :
Web Connection Port : Port 80 TCP
Authentication and Control Port : Port 9000 TCP
Video Streaming Port : Port 9001 TCP
Motion Detectin Control Port : Port 9005 TCP
6-2. Broadband (ADSL, Cable, Fiber Optic) Modem Environment
Home, store, small office use one Broadband modem (DSL, Cable Modem), and use one
public IP address. In order to use several PC through one Public IP address, the user in most cases
use IP sharing device. We recommend to use a IP router (IP Sharing device) to install the THE
CAMERA. There may be a case in no need of router, but most people use THE CAMERA and other
PC 1set or more. When using the router, connect the router and input IP address of THE CAMERA
(IP address of THE CAMERA is set as 192.168.1.7 on ex-factory) in DMZ menu. If the user cannot
use the DMZ function because there is no DMZ menu in the router or some other reasons, go into
port forwarding or NAT menu on the router and map the port of THE CAMERA one by one. User can
check the current port setting of THE CAMERA from “Administrator's Page”->”Network Setting”-
>”Port Setting” (see ‘ 3. Basic Setting ‘). Manufacturer’s setting of THE CAMERA is as follow on ex-
factory : (The user can change port if necessary).