Sony DSR-2000AP - Manual (Page 114)

Chapter 6
Setup Menu
114
Chapter 6 Setup Menu
Extended Menu
Item number Item name Settings
Menu items in the 300s, relating to editing operations (continued)
307 AUTO-DELETION
FOR
INCONSISTENT
DATA Select what happens when an erroneous edit point is set.
MANU : A warning is given by flashing the DELETE button on the lower control panel.
The operator must manually delete the unnecessary edit point .
NEG&E: When inconsistent edit points are set, such as when an OUT point is before an
IN point, or an audio OUT point is before an audio IN point, or when too many edit
points are specified, the previously set edit point is deleted.
NEG: When inconsistent edit points are set, such as when an OUT point is before an IN
point, or an audio OUT point is before an audio IN point, the previously set edit point
is deleted. When too many edit points are specified, the DELETE button on the
control panel flashes to give a warning.
Note
Pressing the button corresponding to an edit point to be deleted and the DELETE button
simultaneously deletes the edit point. If an erroneous edit point is set (the DELETE
button is flashing), editing is not executed.
(Continued)
308 SELECTION OF
STD/NON-STD
FOR ANALOG
VIDEO IN When no signal is input to the REF. VIDEO IN connector, select whether or not to
synchronize the playback circuits with the input analog video signal.
STD : Synchronize. Use this setting when a standard signal is always input (forced STD
mode).
N-STD: Do not synchronize. Use this setting when the input video signal is unstable
(forced N-STD mode).
Note
When using a VCR with no built-in time base corrector (e.g. a home-use VHS-system
VCR), select N-STD.
311 ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH1
312 ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH2
313 ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH3
314 ANALOG AUDIO
EDIT PRESET
REPLACE FOR
CH4
Items 311 to 314: When using an editor (PVE-500, BVE-600, etc.) or a remote controller
which cannot control digital audio edit preset, select how to activate edit preset of each
digital audio channel on this unit using the analog audio edit preset function of the editor
or remote controller.
Set edit preset of each digital audio channel (channels 1 to 4) of this unit on or off
according to the analog audio preset specified by the remote controller or editor.
NO DEFINITION
ANALOG CH1: Follow edit preset of analog channel 1.
ANALOG CH2: Follow edit preset of analog channel 2.
ANALOG CH1+CH2: Follow edit preset of analog channel 1 or 2.
The default settings for each item are as follows:
311: ANALOG CH1
312: ANALOG CH2
313: NO DEFINITION
314: NO DEFINITION
317 AUDIO EDIT
MODE Specify the type of editing for audio signals.
CUT: Cut editing (discontinuity in audio signal may result at the editing point, causing
noise during playback.)
CROSS FADE : Cross-fade
FADE: Fade in and fade out
IN OUT
IN/OUT