Sony DSR-2000AP - Manual (Page 47)

Chapter 3
Recording and Playback
Chapter 3 Recording and Playback
47
Recording Time Code and User Bit Values
There are the following two ways of recording time code:
• Setting an initial value, then recording the output of the internal time code
generator
• Recording the output of the internal time code generator synchronized to
an external time code generator
To set an initial value then record the time code
Use the procedure described in the section “Setting an initial time code
value” (page 40), then carry out the recording operation (see page 48).
Setting the time code value to the current time
See page 41.
Setting a user bit value
See page 42.
To synchronize the internal time code generator to an external
signal
See page 43.