Sony DSR-2000AP - Manual (Page 64)

Chapter 3
Recording and Playback
64
Chapter 3 Recording and Playback
Digitally Dubbing Signals in DVCAM Format
6
Press the SET button.
The recording tape and source tape are both automatically wound back
to the beginning, and dubbing starts. At the same time, the screen
changes as follows.
To end the dubbing operation while it is in progress
Press the STOP button.
The dubbing operation stops and a message asking whether to copy the
contents of the cassette memory appears.
For more information about this, see the section “If you end dubbing while it
is in progress” (page 65).
When dubbing is completed
1 A message “COMPLETED” appears on the monitor.
2 The source tape and recording tape are both automatically rewound
to the beginning, and the cassettes ejected.
3 The unit returns to the state in step 4.
7
To continue by dubbing another tape, repeat steps 5 and 6.
8
To end the dubbing operation and exit from the menu, press the
MENU button.
SDTI DUBBING
(A/V/TC/CM)
EXECUTING.
TCR 00:00:00:00
UBR 00:00:00:00
ABORT:MENU KEY