Sony DSR-2000AP - Manual (Page 99)

Chapter 5
ClipLink Operation
Chapter 5 ClipLink Operation
99
1
Using the search dial, move the selection mark
(asterisk) to the desired data item on the ClipLink
log data list.
The Mark IN point address is stored as the IN
point and the Mark OUT point address is stored as
the OUT point. At the same time, the IN button
and OUT button light and the ENTRY/SHIFT
button starts flashing.
2
Perform either one of the following operations.
• Hold down the ENTRY/SHIFT button and press
the LIST/– button, exiting from the ClipLink log
data list.
• Cue up to the IN point or OUT point. (See page
97.)
3
Cue up to the tape position to be made the new
Mark IN point. (See page 71.)
4
Holding down the IN button, press the ENTRY/
SHIFT button.
The ENTRY/SHIFT button lights and the Mark IN
point address changes.
5
Cue up to the tape position to be made the new
Mark OUT point. (See page 71.)
6
Holding down the OUT button, press the ENTRY/
SHIFT button.
The Mark OUT point address changes.
7
Holding down the ENTRY/SHIFT button, press
the LIST/– button to display the ClipLink log data
list, then make sure the selection mark (asterisk) is
kept at the position of the desired data item
selected in step 1.
If the selection mark (asterisk) is at a wrong
position
Using the search dial, return the selection mark to
the desired data item.
8
Holding down the ENTRY/SHIFT button, press
the MARK/+ button.
The ENTRY/SHIFT button goes out and the Mark
IN point and Mark OUT point addresses are
rewritten.
Changing the OK/NG Status
To change the OK/NG status of the data item selected
on the ClipLink log data list, proceed as follows.
1
Using the serarch dial, move the selection mark
(asterisk) to the desired data item on the ClipLink
log data list.
2
Hold down the STOP button and press the SET
button.
The following setting screen appears.
3
Hold down the SEARCH button and turn the
search dial to change the setting to OK or NG as
required.
4
Holding down the ENTRY/SHIFT button, press
the MARK/+ button.
The OK/NG status is rewritten.
2,5
1
3 4
(003/196)
* 3 M 00:03:50:00 OK
OK/NG OK
CLIPLINK LOG DATA LIST
(Continued)