Sony DSR-2000AP - Manual (Page 49)

Chapter 3
Recording and Playback
Chapter 3 Recording and Playback
49
Playback
This section describes playback of video and audio.
Preparations for Playback
Button/switch settings
Before beginning playback, make any necessary button/switch settings.
For details of the settings of each of the buttons/switches, see the pages indicated
in parenthesis.
Time data selection
Displayed time data
Use the COUNTER SEL button to select one of counter’s count
(COUNTER), time code (TC), and user bit values (U-BIT). When you
select time code, the data displayed is determined by the setting (TC/
VITC) of the TC SELECT switch on the subsidiary control panel as
follows.
MONITOR SELECT buttons (page 18) : select the audio channels to be monitored.
POWER switch: 1 side
PB controls (page 17) :
adjust the audio
playback levels.
REMOTE button (page 16) : unlit
COUNTER SEL button (page 19) :
select the data to be displayed
(see the section “Displayed time
data” on this page)
.
PB button (page 19) : lit
TC SELECT switch (page 27) : TC or VITC (when displaying time
code) (see the section “Displayed time data” on this page)
TC SELECT switch setting Displayed data
TC TC recorded on tape
VITC VITC recorded on tape