Sony DSR-2000AP - Manual (Page 31)

Chapter 1
Overview
Chapter 1 Overview
31
8 COMPONENT VIDEO Y/R–Y/B–Y IN
connectors (BNC type)
Input analog component video signals (Y/R
−Y/B−Y)
to these connectors.
9 COMPONENT VIDEO Y/R–Y/B–Y OUT
connectors (BNC type)
These connectors output analog component video
signals (Y/R
−Y/B−Y).
!º VIDEO OUT 1, 2, and 3 (SUPER) connectors
(BNC type)
These connectors output analog composite video
signals.
When the CHARACTER switch on the subsidiary
control panel is set to ON, connector 3 (SUPER)
outputs a signal with superimposed text information.
2 Digital input/output section
DIGITAL AUDIO I/O(AES/EBU) SDTI(QSDI)
SDI INPUT SDI OUTPUT
i.LINK
OUT
(SUPER)
IN
INPUT OUTPUT
1 2 3
CH-1/2
CH-1/2
CH-3/4
CH-3/4
1 DIGITAL AUDIO (AES/EBU) IN connectors
2 SDTI(QSDI) INPUT connector
3 SDTI(QSDI) OUTPUT connector
4 i.LINK connector
5 DIGITAL AUDIO
(AES/EBU) OUT connectors
6 SDI INPUT connectors 7 SDI OUTPUT 1, 2, and 3 (SUPER)
connectors
1 DIGITAL AUDIO (AES/EBU) IN connectors
(BNC type)
Input digital audio signals in AES/EBU format to these
connectors.
The left-hand connector (CH-1/2) is for audio channels
1 and 2, and the right-hand connector (CH-3/4) is for
audio channels 3 and 4.
2 SDTI (QSDI) (Serial Data Transport Interface
(QSDI)) INPUT connector (BNC type)
Input digital video and audio signals in SDTI (QSDI)
format to this connector.
3 SDTI (QSDI) (Serial Data Transport Interface
(QSDI)) OUTPUT connector (BNC type)
This connector outputs digital video and audio signals
in SDTI (QSDI) format.
Note
If you monitor the output signal from this connector on
another device in E-E mode while making a search at
speeds in the range +1 to +
1 /
30
or – 1 /
30
to –1 times
normal speed, the signal may sound differently than it
does on this unit.
4 i.LINK connector (6-pin IEEE-1394)
This connector inputs and outputs digital video and
audio signals in DV format.