Sony Metz SCA 3302 M7 - Manual (Page 29)

mecablitz 60 CT-4, 45 CL-4, 45 CL-4 digi,
32 MZ-3, 32 Z-2
Select “M” or a partial light output on the meca-
blitz. Find the required working aperture using the
aperture calculator on the mecablitz. Then set on
the camera this working aperture or the aperture
that comes closest to it.
In the camera mode M it is additionally necessary
to set a shutter speed that equals or is slower than
the camera’s fastest synch speed. Use a tripod for
slow shutter speeds to prevent camera shake.
mecablitz 40 MZ-..., 44 MZ-2, 50 MZ-5, 54 MZ-...,
70 MZ-..., 76 MZ-5 digi:
The camera automatically transmits the adjusted
aperture to the mecablitz. Set the appropriate aper-
ture/partial light output combination (camera /
mecablitz) to determine the required flash-to-subject
distance. The distance for a correct exposure is indi-
cated on the LC display of the mecablitz and is
adapted to the aperture and partial light output set-
ting.
In the camera mode M it is additionally necessary
to set a shutter speed that equals or is slower than
the camera’s fastest flash synch speed. Use a tri-
pod for slow shutter speeds to prevent camera
shake.
4.15.1 Manual flash mode M with digital
cameras
If a digital camera Dimage ... is used with a meca-
blitz that works in the manual flash mode M, a mea-
suring preflash will not be fired before shooting the
picture. Consequently, the camera will not conduct
29
ķ
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 29