Sony Metz SCA 3302 M7 - Manual (Page 34)

the controller of the 70 MZ-... and 76 MZ-5 digi),
mount on the camera and switch on. Switch the
camera to wireless controller mode (see the opera-
ting instructions for the given camera). Lightly
touch the shutter release without tripping the shut-
ter. The mecablitz is switched over to slave mode.
“SL” is indicated on the display as well as the
remote address: “Ad1” to “Ad4” are possible. Only
"Ad1" is possible with 44 MZ-2.
The additional “rA1” and “rA2” (only with
54 MZ-..., 70 MZ-... and 76 MZ-5 digi) display
is only of significance when in “Ratio” mode
with two slave flash units (mecablitz)!
To change the remote address (only with 54 MZ-...,
70 MZ-... and 76 MZ-5 digi) depress the “Mode”
button on the mecablitz until “TTL” flashes on the
display. Turn the setting disk and adjust the re-
quired remote address. Press the setting disk in
the direction of the arrow to store the setting. Stor-
age is automatic after 5 sec. if the setting disk is
not pressed. Finally, lightly touch the shutter relea-
se without tripping the shutter. The camera will
now automatically take over the remote address of
the mecablitz.
Remove the mecablitz with the SCA 3302 adapter
from the camera and mount on the stand (optio-
nal). Set up the mecablitz with stand in the requi-
red position or mount on a tripod.
The slave settings for the remote address (Ad1
to Ad4) and the automatically controlled light
output ratio (rA1 or rA2) are retained after the
mecablitz (only with 54 MZ-..., 70 MZ-... and
76 MZ-5 digi) has been switched off.
☞
☞
34
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 34