Sony Metz SCA 3302 M7 - Manual (Page 41)

• Press the "Set" key on the mecablitz and use the
̆̄ keys to select a remote address Sl1. . . . Sl4
• Press the "Set" key on the mecablitz
• Touch the camera's release button in order for
the remote address you have set to be adopted
by the camera.
• The display of the mecablitz shows "SL" under
the TTL display
• Disconnect flashgun and camera
• Open out the camera flash
• Trigger a test flash on the camera, the slave
flashgun should respond with a delayed flash
• The setup is now ready to use
Important: When the slave flashgun is switched
off it loses the remote function and has
to be switched back into remote mode
by connecting it with the camera.
It is possible to deactivate the remote function:
a) by switching off the remote function on the
flashgun
b) by deselecting "WIRELESS" on the camera
Testing the “Ratio” mode:
Switch on the camera and the controller or fold out
the camera’s built-in flash. Await the flash readi-
ness signal of the controller or the camera’s flash
unit. Fire a remote test flash with the SPOT or AEL
button on the camera.
On some cameras the flash button must be
simultaneously kept depressed (refer to the
☞
41
ķ
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 41