Sony Metz SCA 3302 M7 - Manual (Page 46)

ing is not specifically displayed by the mecablitz.
The mecablitz will not fire a pre-flash when:
The reflector is swivelled out of its normal
position.
Second-curtain synchronisation has been set
(REAR mode).
The secondary reflector of the mecablitz has
been switched on.
The camera operates with mirror lock-up.
In this instance the mecablitz will operate with
normal TTL flash control.
To ensure proper operation of multi-zone flash
exposure metering with the above cameras no
filter attachments (e.g. neutral density or
colour effects filters), diffusers (bouncers) etc.
must be mounted in front of the reflector. The
wide-angle diffuser (20mm) integrated in the
mecablitz must not be swivelled in front of the
reflector. Multi-zone flash exposure metering
must be deactivated if any of the aforemen-
tioned attachments are to be used. For this
purpose it will be sufficient to switch the
mecablitz from TTL-HSS mode to TTL mode
(see Section 4.13.2 or refer to the camera’s
operating instructions).
4.18.2 Dimage A1, A2, 5, 7, 7i, 7Hi
For system-induced reasons TTL pre-flash
metering with the above digital cameras is
possible with the following flash units: meca-
blitz 32 Z-2, 32 MZ-3, 40 MZ-1, 1i, 3, 3i,
☞
☞
☞
46
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 46