Sony Metz SCA 3302 M7 - Manual (Page 39)

Initially, the display of the mecablitz will indicate
“SL”, “Ad1” and “rA1”. This means that the meca-
blitz has been set to slave mode (SL) with the
remote address 1 (Ad1). In Ratio mode a 1/3 light
output is assigned to the mecablitz (rA1). To adjust
the required settings press the “Mode” button on
the mecablitz until ’”TTL” flashes on the display.
Turn the setting disk anti-clockwise until “Ad2”
(remote address 2) and “rA2” (2/3 light output) are
displayed. Press the setting disk in the direction of
the arrow to store the setting. Storage is automatic
after 5 s if the setting disk is not pressed.
Lightly touch the camera’s shutter release so that
the camera can take over the remote channel set-
ting from the mecablitz. Remove the mecablitz with
the SCA 3302 adapter from the camera and mount
on the stand (optional). Place the mecablitz with
stand in the required position or mount on a tripod.
Both slave flash units must be set to the same
remote address “Ad...”! The display of one
slave must indicate “rA1”, and the other “rA2”.
Setting procedure with the mecablitz 45CL-4
digital
This flashgun only supports remote address 1.
• Equip flashgun with adapter.
• Attach flashgun with adapter to the camera.
• Switch on the flashgun and set to "TTL".
• Switch on the camera and set to "WIRELESS".
• Activate the camera by touching the release button.
• "TTL" disappears from the flashgun's display
window and the " " appears indicating that
☞
39
ķ
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 39