Sony Metz SCA 3302 M7 - Manual (Page 42)

camera’s operating instructions for details). If
the set-up operates correctly the slaves will
respond successively with a brief flash. The
set-up is then ready for shooting.
If a slave flash unit does not respond, then re-
align the sensor of the SCA 3302 adapter so
that it recognises the controlling pulses from
the controller and repeat initialisation (see
above). Finally, repeat the test flash procedure.
To terminate the “Ratio” mode with two slave flash
units and continue with only one slave, it is suffi-
cient to simply switch off any one of the two units.
The indication of “rA1” and “rA2” on the dis-
play of the mecablitz is only of significance if
two slave flash units are being operated.
Setting procedure for the mecablitz 40 MZ-...
and 50 MZ-5:
Attach the SCA 3302 adapter to the mecablitz (or
controller of 50 MZ-5) and switch on.
Press the “Remote” button on the mecablitz until SL
is indicated on the display. Select the required light
output ratio with the “+” or “-” button. SL (slave)
and the selected light output ratio (rA1 for 1/3 and
rA2 for 2/3) will be displayed.
Mount the mecablitz with SCA 3302 adapter on the
stand (optional). Place the mecablitz with stand in
the required position or mount on a tripod.
The ratio setting of the mecablitz is retained
after the flash unit has been switched off.
☞
☞
☞
42
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 42