Sony Metz SCA 3302 M7 - Manual (Page 44)

Deactivating the Minolta TTL remote mode:
Mount the mecablitz with SCA 3302 adapter on the
camera. Switch on the camera and the mecablitz.
Cancel the “Wireless” or “WL” remote function on
the camera (see operating instructions for the
given camera). Lightly touch the shutter release
without tripping the shutter. This deactivates the
slave mode on the mecablitz which will then oper-
ate in normal mode.
With the mecablitz 44MZ-2 the slave mode is can-
celled when the mecablitz switches to standby
mode (Auto-Off) or when it is switched off by way
of the main switch.
4.17 Cordless Metz Remote Mode
The mecablitz flash units 40 MZ-..., 44 MZ-2,
50 MZ-5, 54 MZ-.., 70 MZ-.. and 76 MZ-5 digi
permit wireless TTL flash operation (Metz TTL
Remote) and wireless automatic flash control
(Metz Automatic Remote) with several flash
units (44 MZ-2 only as a slave). The camera is
not switched to "Wireless" mode (WL) for the
cordless Metz remote mode!
Light output control of the off-camera mecablitz
flash units (slaves) is handled by the mecablitz
mounted on or at the camera which functions as
the controller. Off-camera slave flash units additio-
nally require the slave adapter "SCA 3082" or
"SCA 3083 digital" for the Metz remote mode.
Please refer to the corresponding section in the
operating instructions of your mecablitz for the set-
ting procedure of the Metz Remote Mode.
☞
44
700 47 0113.A10 GB-I-E 20.02.2008 13:15 Uhr Seite 44