SMC Networks BARRICADE SMC7901WBRA2 B1 - Manual (Page 117)

C HAPTER 10 | Advanced Configuration
RIP Configuration
– 117 –
RIP C ONFIGURATION
RIP is an Internet protocol you can set up to share routing table
information with other routing devices on your LAN, at your ISP’s location,
or on remote networks connected to your network via the ADSL line. Most
small home or office networks do not need to use RIP; they have only one
router, such as the ADSL Router, and one path to an ISP. In these cases,
there is no need to share routes, because all Internet data from the
network is sent to the same ISP gateway.
Figure 70: Dynamic Routing
The following items are displayed on this pages:
◆ RIP — Enables or disables RIP on the unit. (Default: Disabled)
RIP C ONFIG T ABLE
The RIP Config Table configures RIP related parameters on the unit.
◆ Interface — The name of the interface on which you want to enable
RIP. (Default: br0)
◆ Receive Mode — Indicate the RIP version in which information must
be passed to the DSL device in order for it to be accepted into its
routing table.
◆ Send Mode — Indicate the RIP version this interface will use when it
sends its route information to other devices.
◆ Add — Adds an entry to the table.
◆ Select — Highlights a table entry.