Sharp MX-C401 - Manual (Page 590)

5-52
SCANNER/INTERNET FAX
Contents
Specifying the original scan size (by paper size)
If the size of the placed original is different from the displayed original size or you wish to change the original size, you
must touch the [Original] key and directly specify the original size.
Place the original in the document feeder tray or on the document glass and follow the steps below.
1
Select the mode and display the image settings screen.
(1) Touch the tab of the mode that you wish to use.
(2) Touch the [Original] key.
The original size set in the system settings appears to the right of the [Original] key.
☞
IMAGE SETTINGS (page 5-49)
2
Touch the [Scan Size] key.
3
Specify the scan size.
(1) Touch the appropriate original size key.
(2) Touch the [OK] key.
• If you are sending a long original, touch the [Long Size] key. Use the automatic document feeder to scan a long
original. The maximum width that can be scanned is 19-5/8" (500 mm) (the maximum height is 8-1/2" (216 mm)).
• To specify an AB size for the scan size, touch the [AB Inch] key to highlight the [AB] side and then specify the scan size.
4
Touch the [OK] key.
When [Long Size] is selected, the 2-sided scanning setting and send size cannot be changed. In addition, when only scan
destinations are selected for scan transmission or metadata transmission, scanning will take place in Mono2.
Scan/Original OK
Auto
Scan Size
2-Sided
Tablet 2-Sided
Booklet
Send Size 100%
Image Orientation
8½x11
8½x11 8½x14
Scan/Original
8½x13 Long Size
OK
Inch
AB
Size Input
8½x13 5½x8½
(2) (1)
Scan/Original OK
Auto 5½x8½
Scan Size
2-Sided
Tablet 2-Sided
Booklet
Send Size 100%
Image Orientation