Sony DVS-9000 - Manual (Page 191)

191
C:\WINNT\Profiles\Administrator\Desktop\WORK_08_21\370467401
DVS9000WW\01GB05C03-WW.fm masterpage:Right
Executing a Transition
Chapter 3
T
ransitions
DVS-9000/9000SF
3-704-674-01 (1)
2
Press the [Pattern Limit] button, turning it on.
3
Adjust the following parameters.
a) 0.00%: Executing the transition does not change the video output at all.
b) 100.00%: The transition is the same as when no pattern limit is set, but the cross-point
button selections of the background A and B buses do not interchange when the transition
completes.
c) This only appears when the Setup setting is made so that the transition is executed the
instant that the pattern limit is released. (See “Settings Relating to Keys, Wipes and Frame
Memory (Key/Wipe/FM Menu)” in Chapter 16 (Volume 2).)
Executing a pattern limit transition
Use the following procedure.
1
Press the [PTN LIMIT] button, turning it on.
The button you pressed lights amber.
2
Carry out the transition.
The transition progresses as far as the set pattern limit. Even if the
transition completes, the cross-point button assignments of the background
A and B buses do not interchange.
3
Carry out the transition once again.
The status before the previous transition is restored.
To cancel the pattern limit
To cancel the pattern limit after completion of step 3 of the above procedure,
press the [PTN LIMIT] button, turning it off.
If after carrying out step
2 above, the pattern limit has been reached, carry out
the following procedure.
1
Press the [PTN LIMIT] button.
The button you pressed lights green.
2
Carry out the transition.
The [PTN LIMIT] button goes off, and the pattern limit state is released.
Depending on the way in which the transition was executed, the action will
be as follows.
Knob Parameter Adjustment Setting values
1 Pattern Limit Pattern limit 0.00 a) to 100.00% b)
2 c) Transition rate Transition rate 0 to 999 (frames)