Sony DVS-9000 - Manual (Page 194)

Chapter 3
T
ransitions
C:\WINNT\Profiles\Administrator\Desktop\WORK_08_21\370467401
DVS9000WW\01GB05C03-WW.fm masterpage:Left
194
Executing a Transition
DVS-9000/9000SF
3-704-674-01 (1)
If the transition rate is set to 100 frames, and the fader lever has moved
through 1/4 of the transition, then the remaining 3/4 of the transition is
carried out in 100 frames.
Non-Sync State
If the fader lever is in an intermediate position when a transition is completed
as an auto transition, then the lever position no longer agrees with the transition
state. This is termed a non-sync state.
In a non-sync state, two lit LEDs indicate the position from which a normal
transition can be carried out. This is either at one end position or both end
positions of the fader lever travel.
Moving the fader lever toward the position of the lit LEDs does not carry out a
transition, but when the fader lever reaches the end position the non-sync state
is released, and it is now possible to carry out the next transition.
• If the fader lever is moved in the direction away from the lit LEDs, this
carries out the next transition, over the remaining part of the fader lever
travel.
• Even in a non-sync state, you can carry out an auto transition by pressing the
[AUTO TRANS] button. During the auto transition, the indicators show the
transition progress in the usual way, but when the transition completes, they
once again indicate the non-sync state.
Manual transition completed as auto
transition when moving the fader
lever upward: Top two LEDs light. Manual transition completed as
auto transition when moving the
fader lever downward: Bottom two
LEDs light.
Once the fader lever is moved
to this position, the non-sync
state ends, and the next
transition (direction shown by
the arrow) is possible.