Transparency film with insert sheets, Ge 5-22), E 5-22) – Sharp AR-M700N User Manual
Page 118: Load transparency film into the bypass tray, Touch the [transparency] key, Touch the [ok] key, Select the bypass tray, Special modes
Transparency film with insert sheets
When copying onto transparency film, blank insert sheets can be placed between transparent sheets.
● This function only operates in "one-sided to one-
sided" and "two-sided to one-sided" modes.
● Multiple copies cannot be selected in this mode.
● The inserts are inserted under each transparency
as shown at left.
● Select insert paper that is the same size as the
● When feeding insert paper from an inserter,
copying on the insert paper is not possible.
● Transparencies can be fed from the bypass tray
or tray 3.
● If the transparencies are loaded in tray 3, be sure
Load transparency film into the bypass
Touch the [PAPER SELECT] key in the
main screen and select the bypass tray
paper type in the paper setting screen
(touch (X) below).
Touch the [TRANSPARENCY] key.
Touch the [OK] key.
If the paper size was changed from an AB size to
an inch size, or from an inch size to an AB size, be
sure to set the paper type and size as explained on
steps 5 to 7 on page 2-10 and steps 8 to 10 on
Select the bypass tray.
Touch the [TRANSPARENCY INSERTS]
key in the special modes screen (2nd
The Transparency inserts
setting screen will appear.
The transparency inserts
, etc.) will also
appear in the upper left
corner of the screen to
indicate that the function
is turned on.
Example: Inserting insert sheets between transparencies
Two-sided originals are
only supported when
feeding is used.
Inserts can also be
If the transparencies are loaded in tray 3, steps
1 to 5 below are not necessary.
2. 8 x11
5. 8 x11
NON STANDARD SIZE
5. 8 x11