Kyocera DP-3600 - Manual (Page 123)

Setting the Paper Type
2-55
4. Pressing the ENTER key will cause the ? to disappear. Pressing the EXIT key will exit the setting.
The same procedure can be used to set the parameters on other submenus.
Note that the setting status for paper weight and fuser mode used for each paper type is as given in
the table below. In addition, all paper type settings made using Custom setup can be reset to
the default values shown in the table below using the >Reset custom setup menu.
Paper Type
Plain
Trans-
parency*
Pre-
printed
Labels Bond Recycled Vellum* Rough Letter
head
Color Pre-
punched
Envelope Card
stock
Custom
Vellum 1
Low 1 1 1 1
Middle 1 1 1 1
High 1 1 1 1 1
Paper
weight
Light
(Thin)
1
Normal 1 1 1 1 1 1 1 1 1 1 1
Heavy
(Thick)
1 1
*: These cannot be selected when the paper source is EF-100.
Fuser
mode