Kyocera DP-3600 - Manual (Page 175)

Indicators and Messages
5-11
Message Corrective Action
Warning
Low memory
The printer’s internal memory is running low.
Remove any unnecessary download fonts and/or macros. You can check the
amount of user memory currently available by printing a status page.
Toner low There is not enough toner inside the toner container.
There is not enough toner. Prepare a new toner container. (See Chapter 4.)
Replace Toner
Clean printer
There is no more toner in the toner container.
The printer has stopped because there is no more toner. Replace with a new
toner kit. After replacing, be sure to clean the printer. (See Chapter 4.)
Option interface
Error
A failure has occurred with the option interface.
Check the option interface installed on the printer.
HARDDISK error20 Install the harddisk unit into the OPT2 slot.
This message is displayed when the optional harddisk unit is accidentally
installed into the OPT1 slot. Be sure to install the harddisk unit in the OPT2
slot. Be sure to turn off the printer’s power before removing the incorrectly
installed harddisk.
RAM DISK error ##
Press CONTINUE
Check the error code displayed in the place of ## and refer to the
appropriate description below.
01: Abnormal format. Try turning the power off and on again.
02: RAM DISK mode is Off. Turn RAM DISK mode On.
03: Cannot write to the disk system because it is write protected. Remove
the write protection.
04: No disk space. Clean up files.
05: Specified file not on disk.
06: No memory for use by disk system. Expand printer memory.
10: Cannot format disk because host data is spooled there.
Format the disk after Ready is displayed.
(Continued on next page)