Kyocera DP-3600 - Manual (Page 172)

Chapter 5 Troubleshooting
5-8
Indicators and Messages
This section explains the indicators on the control panel and the messages which appear in the
message display and the appropriate corrective action to take in each case.
Indicators
Indicator Condition Corrective Action
Flashing
The printer has run low on toner. The toner should be replaced
as soon as possible. Clean the printer after replacement. (See
Chapter 4.)
Lit
Toner is low or has run out. Replace with a new toner
container. (See Chapter 4.)
Fast Flashing Paper is jammed in the location flashing.
Slow Flashing
The paper has run out in the paper cassette or multi-purpose
tray. Add paper to the paper feed source. (See Chapter 1.)
Lit
This indicates either the current paper feeder or the paper
output point.
Flashing
A paper jam has occurred in the optional duplex printing unit
(AD-31). Remove the paper jam referring to the instruction
manual for the AD-31.
Lit
An optional duplex printing unit (AD-31) has been attached,
and the printer is printing in duplex printing mode.
Flashing
The printer is warming up (Please wait) or the printer has
insufficient memory available. Confirm the message indicated
on the message display.
ATTENTION
Lit
A message will be displayed in the message display. Take
corrective action according to the message displayed. The
table on the following page lists the corrective action to take in
response to each message.