Kyocera DP-3600 - Manual (Page 124)

Chapter 2 Operating the Page Printer
2-56
Sleep Timer Setting
This printer is equipped with a sleep timer function for conserving energy in cases where there has
been no operation from the control panel or data has not been received for a predetermined period of
time.
The sleep timer can be set anywhere from 0 to 120 minutes in 5-minute increments. Setting the sleep
timer to 0 turns it off. The sleep timer is set at the factory to 30 minutes.
Once the set time arrives, the printer will display Sleeping and all indicators will go out. This
minimizes the amount of energy used.
Pressing a key on the control panel, opening and closing a cover, or sending data to the printer while it is
displaying Sleeping will cause the printer to display Please wait and it will begin warming up.
After it warms up, the printer's ON LINE indicator will light and it will enter ready status.
Note______________________________________________________________________
The printer environment last set is still maintained even though all indicators are out while the printer is in
Sleeping mode.