KORG Electronic Keyboard - Manual (Page 1049)

Option boards/Memory/Calendar battery Installing an option board/memory/calendar battery
1039
3. Raise the cover to the angle shown in the
following illustration; then pull out and remove it.
Be careful not to drop the cover or screws inside the
OASYS.
4. Spread open the security latches at each end of the
DIMM socket.
5. Remove the memory module from its package.
Be careful not to touch the contacts or the
components.
6. Insert the memory module into the DIMM socket.
Align the notch of the memory module with the
divider inside the DIMM socket.
7. Press down on the memory module; the security
latches will close, fastening the memory module
in place.
Note: If the security latches do not close, use your
finger to push them closed.
8. Close the memory/calendar battery cover.
Insert the lip at the front of the cover into the
groove, and align the screw holes. Use the two
screws to fasten the cover in place.
9. Close the front panel as described in “Opening
and closing the front panel,” steps 8 and 9.
10.When you are finished, turn on the power and
verify that the memory was installed correctly.
(See “Checking after installation” on page 1036)
Removing DRAM DIMMs
1. Open the DIMM socket security latches that hold
the memory module in place.
2. Gently remove the memory module, and keep it in
a safe place.
Use caution; when you spread open the security
latches, the memory module may pop out and fall
inside the OASYS.
Security
latches
Divider
Notch