KORG Electronic Keyboard - Manual (Page 686)

Global mode
676
Linear means that the two samples will each be at 50%
of their full volume in the middle of the crossfade.
Sometimes, this may create a dip in the volume level; if
so, try using Power instead.
Power, short for Equal Power, means that the two
samples will each be at around 70% of their full
volume in the middle of the crossfade. Sometimes, this
may create a bump in the volume level, in which case
you might try selecting Linear instead.
Layer means that the two drum samples will be
layered together, both at full volume, for the entire
range of the crossfade.
Crossfade Curves
DS2(Mid Hi): (Drumsample2 Mid High)
DS3(Mid Lo): (Drumsample3 Mid Low)
DS4(Low): (Drumsample4 Low)
These are the settings for the second, third, and fourth
velocity zones. The parameters for DS2 (Mid Hi) and
DS3 (Mid Lo) are exactly the same as those for DS1, as
described above.
The parameters for DS4 (Low) are also similar to those
for DS1, except that DS4 (Low) has no settings for
Bottom Velocity (which is always fixed at 1), Xfade
Range, or Curve.
▼ 5–1: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Drum Kit. For more information, see
“Write Drum Kit” on page 689.
• 1: Copy Key Setup. For more information, see
“Copy Key Setup” on page 689.
• 2: Swap Key Setup. For more information, see
“Swap Key Setup” on page 689.
Xfade
Power
Xfade
Layer
Linear
Volume
DS1
DS2
Velocity
Volume
DS1
DS2
Velocity
Volume
DS1
DS2
Velocity
Xfade