KORG Electronic Keyboard - Manual (Page 433)

Sequencer P0: Play/REC 0–2: Audio Track Mixer
423
S/P DIF L, R, S/P DIF L/R: Choose these if you want to
record the input from the S/P DIF jack. The input from
the S/P DIF jack will be recorded directly without
passing through the L/R bus, REC buses, or Individual
buses. The S/P DIF L,R input will be connected directly, regardless of the Audio Input (0–8a) settings
for Pan, “Level,” “Solo,” and “Play/Mute.” See the
diagram “REC = S/P DIF L, R,” below.
If “Stereo Pair” is on, S/P DIF L is sent to odd-
numbered tracks, and S/P DIF IN R is sent to even-
numbered tracks.
L, R, L/R: This is the L/R bus, after passing through
both TFX 1 and 2. Choose this if you want to record an
external audio signal being sent to the L/R bus
(specified by 0–8a), or the sound being produced by the OASYS (and sent to the L/R bus) in response to
sequencer playback, keyboard playing, or MIDI input.
See the diagram “REC Source = L, R,” below.
If “Stereo Pair” is on, L is sent to odd-numbered tracks,
and R is sent to even-numbered tracks.
Level Pan
Insert
Effects
CLIP !
Insert
Effects
L/R
Bus
...
Sequencer Playback
Keyboard
Level Pan
Insert
Effects
S/P DIF L
S/P DIF R
REC Source =
S/P DIF L, R
Recording (Multi REC)
Bus = L/R or IFX1-12
Bus = L/R or IFX1-12
Insert
Effects
Level Pan
HDR Track (Mono)
HDR Track (Mono)
REC
1,2,3,4
Indiv.
1,2,3,4,5,6,7,8
Set Play/Rec/Mute
to Rec
S/P DIF L
S/P DIF R
REC Source
L/MONO
R
AUDIO OUTPUT
HEADPHONES
[x] Source Direct Solo
Total
Effects
Master
Effects
Monitor
Level Pan
Insert
Effects
REC Source
= L, R
Insert
Effects
L/R
Bus
...
Audio CD
Total
Effects
Master
Effects
Sequencer Playback
Keyboard
Bus = L/R or IFX1-12
CLIP !
L/MONO
R AUDIO OUTPUT
HEADPHONES
Recording (Multi REC)
Monitor
Bus = Off, Indiv.1...8
Level Pan
HDR Track (Mono)
HDR Track (Mono) L
R
REC Source
Set Play/Rec/Mute
to Rec
REC
1,2,3,4
Indiv.
1,2,3,4,5,6,7,8
When an audio track’s Bus Select is set to L/R, the Rec input will
automatically be muted to prevent a feedback loop. The same will occur if
you set Bus Select to IFX and send the post-IFX signal to the L/R Bus.