KORG Electronic Keyboard - Manual (Page 396)

Combination mode
386
A/B/C/D [Off, On]
Specifies whether the Perf Real-Time Parameter
settings will be valid for each Module.
On (checked): The Perf Real-Time Parameter settings
will be valid.
Off (unchecked): The Perf Real-Time Parameter
settings will be ignored.
Assign [---, Slider1…8, Slider1…8(SW),
SW1…8, DynaMIDI1…8]
For more information, see “Assign” on page 113.
Polarity [+, –]
For more information, see “Polarity” on page 113.
Group: PE (Performance)
For more information, see “Group: PE (Performance)”
on page 113.
Group: Mix
For more information, see “Group: Mix” on page 113.
Run [0000, 0001]
Assign the function of “Run” (0–6b).
+0000: Off
+0001: Run
Please see “Run” on page 328.
Group: Control
Please see “Group: Control” on page 113.
Group: Trigger
Please see “Group: Trigger” on page 114.
Trigger By Module [+0000…+0004]
Assign the function of “Trigger By Module” (7–4a).
+0000: Off
+0001: A
+0002: B
+0003: C
+0004: D
Please see “Trigger By Module” on page 382.
GE Phrase Length [+0000…+0100]
Assign the function of “GE Phrase Length ” (7–4a).
Please see “GE Phrase Length” on page 382.
Group: Key Zones
For more information, see “Group: Zone” on page 114.
Group: Random Seeds
For more information, see “Group: Random” on
page 115.
▼ 7–6: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy KARMA Module. For more information,
see “Copy KARMA Module” on page 408.
• 3: Initialize KARMA Module. For more
information, see “Initialize KARMA Module” on
page 409.
• 4: Copy Scene. For more information, see “Copy
Scene” on page 409.
• 5: Swap Scene. For more information, see “Swap
Scene” on page 409.
• 6: Capture Random Seed. For more information,
see “Capture Random Seed” on page 409.
• 7: Copy From Program. For more information, see
“Copy From Program” on page 405.