KORG Electronic Keyboard - Manual (Page 361)

Combination P1: EQ/Vector/Controller 1–6: Vector CC Control
351
Timbre Center Volume, VJS Assign = –X
Enable Program Vector Volume [Off, On]
When this is turned On, the Program’s Vector Volume
control will function as it does in Program mode,
crossfading between Oscillators 1 and 2. The crossfade
will be controlled by the combination of the Program’s
Vector EG and the Vector Joystick, and is not affected
by the Combi’s Vector EG.
When this is turned Off, the Program’s Vector Volume
control will be disabled.
Timbres 02–16
The parameters for Timbres 2–16 are identical to those
for Timbre 01, as described above.
▼ 1–5: Page Menu Commands
The number before each command shows its ENTER +
number-key shortcut. For more information on these
shortcuts, see “ENTER + 0-9: shortcuts for menu
commands” on page 138.
• 0: Write Combination. For more information, see
“Write Combination” on page 405.
• 1: Exclusive Solo. For more information, see
“Exclusive Solo” on page 138.
• 2: Copy From Program. For more information, see
“Copy From Program” on page 405.
1–6: Vector CC Control
1–6a: Vector CC Control
Vector CC Control lets you use the combination of the
Vector Joystick and the Vector EG to control the
Combi’s Effects.
Each of the four directions of the Vector can send a
different MIDI CC, including left (–X), right (+X), up
(+Y), and down (–Y). You can choose between several
different patterns combining these four directions by
using the VJS X Mode and VJS Y Mode parameters.
The Vector CCs are also sent to all Global Channel
Timbres. These may modulate Program parameters,
like any other MIDI CCs, depending on the settings
within each individual Program.
Volume 50%
100%
0%
Vector X-axis position
-127 0 +127
Center Volume Values: 100
75
50
25
0
1–1a
1–6a
1–6PMC