Konica Minolta Fax 9930 - Manual (Page 41)

|
Konica FAX 9930 26
Accessing Second Panel of One-Touch Keys
To access the second panel of One-Touch keys (41-80), grasp
the latch at the bottom of the keypad and lift up on the main
panel, swinging it up and to the right. After pressing the
desired key(s), close the main panel.
! The One Touch Sheet(s) provide space for Speed Dial
numbers 1 through 80. For Speed Dials 81 and above,
program the number(s) and print the Telephone
Directory.
See “Reports, Telephone Directory.”
Signal Tones
The machine emits sounds to identify specific conditions.
Key Select Tone: This is a short beep that is emitted each
time a key is pressed.
Error Tone: If an inappropriate key is pressed, the machine
emits three short beeps. If there is a problem with operations
during communications, the machine emits five long beeps.
Press the Stop key to stop the beeping (turn the error
tone off), and then print a Message Confirmation Report to
check the source of the problem. To print the report, press the
Enter key twice (with no documents loaded).
End of Session Tone: At the end of each successful faxing
session, the machine emits a long beep to confirm that there
were no errors or problems in the communication.
Off-Hook Alarm Tone: If the machine is equipped with a
telephone handset, and if the receiver of the handset is left
out of the cradle when not in use, the machine emits an
intermittent warbling sound. To turn off the sound, return the
receiver to its cradle or press the Stop key.