Lexmark 5300 - Manual (Page 9)

Related topics:
• “Printing cards” on page 12
Loading iron-on transfers
You can load up to 10 iron-on transfers at once, but you will achieve best results loading them one at a time.
1 Load iron-on transfers with the print side of the transfer facing you.
2 Make sure:
• You follow the loading instructions that came with the iron-on transfers.
• The transfers are loaded in the center of the paper support.
• The paper guides rest against the edges of the transfers.
Related topics:
• “Printing iron-on transfers” on page 13
Loading labels
You can load up to 25 sheets of labels at a time.
1 Load labels with the print side facing you and the top of the sheet fed into the printer first.
2 Make sure:
• The print side of the labels faces you.
• The top of the labels feeds into the printer first.
• The adhesive on the labels does not extend to within 1 mm of the edge of the labels.
• You use full label sheets. Partial sheets (with areas exposed by missing labels) may cause labels to peel off
during printing, resulting in a paper jam.
• The labels are loaded in the center of the paper support.
• The paper guides rest against the edges of the labels.
Note: Labels require more drying time. Remove each sheet of labels as it exits, and allow it to dry to avoid ink
smudging.
Loading transparencies
You can load up to 50 transparencies at a time.
1 Load transparencies with the rough side facing you. If the transparencies have a removable strip, each strip should
face away from you and down toward the printer.
2 Make sure:
• The transparencies are loaded in the center of the paper support.
• The paper guides rest against the edges of the transparencies.
Notes:
• Transparencies with paper backing sheets are not recommended.
• Transparencies require more drying time. Remove each transparency as it exits, and allow it to dry to avoid
ink smudging.
Printing
9