Panasonic KX-FM220 - Manual (Page 47)

47
Advanced
Operations
51
50
50
51
51
51
Operating the answering device from a remote
telephone
The following operations can be performed from a remote location using a touch tone telephone.
Set the unit to ANS/FAX in the AUTO RECEIVE mode before going out (see page 24).
Skips the greeting message
Repeats a message
Skips a message
New message playback
All message playback
Room monitor
Re-records a greeting message
51
49
49
49
49
50
51
Stops re-recording of a greeting
message
Erases a specific message
Erases all messages
Changes to the TEL mode
Turns on message transfer/
pager call for incoming
messages
Turns off message transfer/
pager call for incoming
messages
Dial key Remote command Page Dial key Remote command Page
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
Fold here
1. Call your unit.
2. Enter the remote operation ID
∆∆∆ during the greeting
message.
3. Press the remote command
key(s) (see the reverse side)
within 4 seconds.
or
Wait for 4 seconds. All the
recorded messages will be
played back.
¡ The remote operation is
available only from a touch tone
telephone when the unit is in the
ANS/FAX mode.
¡ When the unit is in the TEL
mode, call your unit and wait for
15 rings.
The answering system will
temporarily answer the line.
Enter the remote operation ID
during the greeting message.
The unit will switch to the
ANS/FAX mode.
¡ When you press any key, press
firmly.
¡ To send a document, press
JI . When a fax tone is heard,
start transmission.
Notice of Remote Operation Answering Device Remote
Operation