Primera Technology Cyclone C-1000 - Manual (Page 11)

Getting Started 7
NOTE: For fastest possible printing, your computer’s parallel port should be
set to ECP mode. If you experience problems with this setting or if
your computer’s parallel port is not ECP compatible, set your
computer’s parallel port to the standard LPT Printer Port setting.
Refer to your computer’s system documentation for instructions on
checking and/or changing the parallel port settings.
1. Connect the Centronics-type parallel side of the cable to
the printer. Snap the fastening clips into place.
2. Connect the other side to the back of your computer at
LPT1, LPT2 or the PARALLEL connector.
3. Alternatively, you can connect the printer with a serial
cable to the RS232C port of your computer or terminal (for
PC compatibles, the RS232C port is COM1, COM2 or
COM3).
4. In preparation for sending your first print job, the printer’s
power should now be turned on.
Note: A Centronics-type parallel connection allows for a much higher
communication speed than the use of RS232C serial.
If you use the serial port with your own cable, refer to
Appendix A and check the pin connection. Be sure that the
speed (baud rate) and protocol are consistent between printer
and host.
510172_r1.qxd 3/21/2001 6:25 PM Page 7