Primera Technology Cyclone C-1000 - Manual (Page 24)

20 Using the Printer with Windows
C. PRINTING LABELS
Now that you have hooked up your printer, loaded the labels
or tags and ribbon, and installed the printer driver software,
you are ready to print your first labels.
1. Go to your Windows-based label design program or install
and launch the software included with your printer called
PrimaBar for Windows.
2. Open or create the label file you wish to print.
3. Once you have opened or created the label you wish to
print, select Print Setup (or the equivalent) from the
program’s File menu to verify that the printer driver
settings are correct for your label size and print file. Be
sure that the proper parameters such as speed, label gap
setting and heat settings are correct for your type of media.
Once these settings are correct, selet Print from the
program’s File menu. Enter the number of labels you wish
to print in the Copies box.
4. The printer driver will begin to process your job.
Depending upon the size of the image, the speed of your
PC’s processor and the amount of RAM you have in your
PC, processing time can be either immediate or take
several seconds.
5. Once processing is complete, the printer will begin to print.
Print time depends upon the Print Speed selection you
made in the Label Dr. 200 settings.
Congratulations! If everything has been done properly, you
should have by now printed your first labels. Consult the
remaining chapters of this manual for information on trouble-
shooting, maintenance and connecting the printer to “legacy”
systems.
510172_r1.qxd 3/21/2001 6:25 PM Page 20