Primera Technology Cyclone C-1000 - Manual (Page 15)

Loading Media 11
8. If the ribbon is already loaded or you just want to print
with direct thermal mode, raise back the Head Latch
Support Bracket and close the print head module by
pushing downward on the Head Latch.
B. LOADING THE RIBBON
1. Open the Side Access Door by lifting it up and to the left.
2. Open the print head module by pushing the Head Latch
toward the rear of the printer. The print head module is
spring-loaded and will automatically open as soon as the
Head Latch is disengaged. Pull down the Head Latch
Support Bracket.
3. Locate the Extra Ribbon Core supplied with the printer.
Place the core on the Ribbon Rewind Spindle, pushing it
all the way to the inside of the spindle.
Sensor Adjust Knob
Head Latch
Empty Core
Ribbon Supply Roll
Ribbon Rewind Spindle
510172_r1.qxd 3/21/2001 6:25 PM Page 11