Primera Technology Cyclone C-1000 - Manual (Page 18)

14 Loading Media
Self Test Pattern
E. RESETTING THE PRINTER TO FACTORY DEFAULT
CONDITION
If you would like to reset the printer to its factory defaults
condition after certain commands have been sent or settings
changed:
1. Turn off the printer. Press and hold the CANCEL button.
2. Turn on the power.
3. The READY LED indicator will blink for few seconds, then
release the button.
4. The READY LED indicator will stop blinking and stays lit.
5. The following parameters automatically reset.
- Label parameters
- Heat (Darkness)
- Speed
- Symbol set (language)
- Others various emulation settings
Notes: 1. It is necessary to perform label sensor calibration after resetting.
2. The printed label count won’t be reset.
510172_r1.qxd 3/21/2001 6:25 PM Page 14