Primera Technology Cyclone C-1000 - Manual (Page 14)

10 Loading Media
3. Move the Label Supply Guide to the outside of the printer.
This allows the maximum label width to be fed through
the machine.
4. Load the label roll onto the Label Supply Spindle. Make
sure the print side of the labels faces upwards when you
pull it towards the print head module. Push the roll all the
way to the inside of the printer and push the Label Supply
Guide snugly against the outside of the label roll. See
diagram above for loading labels and the diagram below
for loading tags. If using fan-fold tags, be sure to remove
the Label Feed Slot cover before loading media. Fan-fold
media must be stacked neatly behind the printer.
5. Move the Outside Label Guide to the outside of the
printer to hold the maximum label width.
6. Inspect the label routing and verify that the path matches
the illustration in the Label Loading Diagram. Move the
Outside Label Guide inwards to keep the labels against
the inside of the printer.
7. Check the Sensor Adjust Knob. Make sure its position is
under the gap path during printing. Adjust it inwards or
outwards if necessary.
Outside Label Guide
Label Supply Guide
Label
Supply
Spindle
Outside Label Guide
Label Supply Spindle
Label Supply Guide
Feed Slot
510172_r1.qxd 3/21/2001 6:25 PM Page 10