Network Instruments GigaStor 114ff - Manual (Page 118)

Configuring virtual adapters on the Gen2 card
Chapter 9 Gen2 Capture Card 118
rev. 1
Figure 78 Assign Port to Virtual Adapter: Default view
3 Select the ports to remove and click Remove. This places them in
the Available Ports list.
4 Change the name of the adapter to something meaningful to you
and click OK (Figure 79).
Figure 79 Assign Ports to Virtual Adapter: Trunk
5 Click New Adapter. The Assign Ports to Virtual Adapter window
opens.
6 Type a name in the Adapter Name box.
7 Select the ports you want to assign to this virtual adapter from the
Available Ports list and click OK.
8 Select the port and click Edit Port. Type a useful description and
click OK. This description appears in the GigaStor Control Panel
in Observer.