Network Instruments GigaStor 114ff - Manual (Page 72)

Configuring the GigaStor through the Control Panel
Chapter 4 GigaStor Control Panel 72
rev. 1
Figure 44 Statistics Lists tab
Subnet
You can specify subnet properties for the GigaStor. Follow the
instructions in “Configuring the GigaStor through the Control Panel”
on page 63 to open the Subnet tab (Figure 45).
Use the Add, Delete, Modify, and Delete All buttons to configure the
subnet settings for the GigaStor. When you define subnets in the
GigaStor, Observer adds that subnet information to the index files.
All future data analyzed will have subnet filtering readily available as
well as statistical data. On the IP stations tab you see your subnets and
you can perform statistical analysis based on subnets.
When you analyze data from captures with index files without any
subnets defined, there will be no subnet available in the IP stations tab
even if the analyzed data includes some index files with the new
subnet information.