Network Instruments GigaStor 114ff - Manual (Page 20)

Setting the GigaStor’s IP address
Chapter 2 Installing Your GigaStor 20
rev. 1
4 Ensure that each drive’s power/activity light is lit. If a drive’s light
is not lit, it is likely that the drive is not seated properly. Turn off
the GigaStor and reseat the drives. For more information, see
“Installing the drives in your GigaStor” on page 50.
5 Log in using the Administrator account. The default
Administrator password is admin.
6 Click Start → Control Panel → Network and Internet Connections
→ Network Connections. Choose Local Area Connection and
right-click and choose Properties.
7 Select Internet Protocol (TCP/IP) from the list and click
Properties (Figure 2).
Figure 2 Default TCP/IP settings
8 Set the IP address, subnet mask, gateway, and DNS server for your
environment and click OK. Click OK again to close the Local
Area Connection Properties dialog. Close the Network
Connections window.
9 Right-click the Probe Service Configuration Applet in the system
tray and choose Open Probe Configuration.